Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Our new WAN provider recommends setting an MTU on our hosts to avoid fragmentation and issues as there are multiple layers of IPSEC encapsulation going on across the WAN.I can't find a command to set the MTU on the CSS11500 the way I can on all my ot...

Hello,is possible to configure connection limit for TFO or I have to buy more RAM? The customer has WAE574 with 3GB - here is connection limit 750. The customer has the following message: The TFO accelerator is overloaded (connection limit). So is po...

Hi,I need some tools to measure the network performance with and without WAAS. I already have WAFS Benchmark (which is really good because I know how much ms it needs to OPEN/SAVE/CLOSE.Besides WAFD BM I have LOADSIM and TCPREPLAY.I would like to tes...

We have ACE10 installed on 7609 Internet-router, we intend to force Internet http traffic on the 7609 to a third party Cache servers without using either PBR or WCCP to obtain backbone bandwidth savings. In addition the ACE will distribute the http t...

exchange1 by Level 1
  • 471 Views
  • 1 replies
  • 0 Helpful votes

Dear all,      i have a content switch CSS11501.The problem happened at 13 AUG from 5:45 AM and solved at 7:11 AM after the restart.Only the management IPs were pingable other interfaces were not pingable.The Content was not seen using CDP.

In our environment we have 2 x 7341 WAAS in HQ and Remote site. We are planning to swap the loan unit with actual one. So for the remote site swapping, is that we just apply the existing configuration in the loan unit to the new unit and then swap th...

ibm.alexl by Level 1
  • 395 Views
  • 2 replies
  • 0 Helpful votes