Application Networking

What I want to do:ACE B, which is in the STANDBY_HOT state should going to ACTIVE mode when ACE A, which is ACTIVE,goes down. ACE B, which is in ACTIVE mode now should stay ACTIVE even when ACE A comes backup.I made already several tests and saw, tha...

Hi allI am facing an issue with waas reporting, in the charts i have OTHER TRAFFIC with a high percentage (50% and sometimes more)What can i do to know which traffic is being categorized as OTHER TRAFFIC so i could create new policy for it

I have an environment where I will be using inline on the remote side and WCCP in the hub. We have a known issue for a set of servers when they are redirected via WCCP. We're using ACL's on the routers to deny WCCP redirection for these servers. Now ...

Hi All ,I want to know if it's possible to make a tunnel between 2WAEs with IP addresses instead of peering based on TCP header manipulation ?Thanks .Regards ,

We have alarms for power supply failure on 7371 box. We replaced the defective power supply . But unable to clear the alarms. How do we clear the alarms ? Our Central Manager still reports that, power supply is still dfective..

We have a CSS that appears to be rewriting the client source IP for HTTP requests with its own IP. This is an issue as we're unable to log the real IPs of the clients requesting HTTP data.The config is attached.Any assistance would be appreciated.

I am getting this major alarm on my core WAE-612-K9- Kernel Crash files and / or User Core files detected .Is this a known problem?Cheers,Nick

We have a CSS11501 which do the load balance and SSL proxy for mail cluster. Mail servers behind CSS need originate traffic to outside through different tcp and udp ports. We setup source group which nat private ip adderss to public ip for outbound c...

We are currently running an older Netapp proxy and are in the process of migrating our inbound web connections to our Cisco 11506 appliance. All is running fine except we have one application that we are filtering a few URL strings on the Netapp and ...

We have a vserver that I set up on a CSM - running v 4.2(9). There is a default serverfarm and an SLB-POLICY that uses an url-map and a different serverfarm. It appears that once the initial connection is made to the default serverfarm any requests t...

Hi,for a customer we need to configure Radius authentication working like this:- CSS administrator login to device at user level- then switch to "enable" mode using a superuser level account.First login to CSS with a Radius account at user level work...