Application Networking

I have a few questions in this regard..1.) Is it possible to use self signed certs for the client authentication, baring in mind you need to point the CSS to the CRL?2.) I need to run around 20 different VIP's (probably on the same IP but with differ...

I am trying to load balance between 2 web servers using the cookie insert method by ACE for achieving the session persistence. The servers are not inserting any cookie. It works fine for the http connections but when trying with https connection it i...

Hi, I want to set up ACE to loadbalance radius traffic between multiple radius daemons running on the same machine (same IP, mutiple radius daemons on different UDP ports). I've researched the available documents and think this would be the required ...

Hi, I have the certificate on my PC and I have ftp access from Cisco ACE. To import the certificate I get below error/xxx.cer: The system cannot find the file specified.Error: Couldn't import file from remote server.If the certificate is in my C:\Cer...

Hi:What would happen if you have two WAN routers at the a data center with WCCP setup on them to inspect traffic and traffic passes through WAN router A and then WAN router B on it way to another site? At the data center there is only one WAE. I have...

Hi,Is there a command on the CSS 11500 series that gives hit counts on ACL's. I'm running v8.10, all I see is: show acl, show acl config, show acl <integer>Thanks!

Hi,What configurations shall required on the ACE to probe for url configured on the Https webserver.To check the availability of the webserver - I need the ACE to probe for the Https://1.1.1.1/Keepalive.html where 1.1.1.1 is the real server.Thanks in...

Hello i have to migrate an service from an alteon to the ace.The traffic from different known sources is going over an transparent proxy into the internet. Based on the source address the traffic should be loadbalanced to different severfarms.My conf...

I'm having some issue with sites being timed our connecting to remote file servers when CIFS AO is enabled in 4.1, the problem goes away if we disable the WAE or the CIFS AO. I'm also noticing some major slow down on my CM since upgrading. So I'm won...