Application Networking

Hi:What would happen if you have two WAN routers at the a data center with WCCP setup on them to inspect traffic and traffic passes through WAN router A and then WAN router B on it way to another site? At the data center there is only one WAE. I hav...

Hi,Is there a command on the CSS 11500 series that gives hit counts on ACL's. I'm running v8.10, all I see is: show acl, show acl config, show acl <integer>Thanks!

Hi,What configurations shall required on the ACE to probe for url configured on the Https webserver.To check the availability of the webserver - I need the ACE to probe for the Https://1.1.1.1/Keepalive.html where 1.1.1.1 is the real server.Thanks in...

Hello i have to migrate an service from an alteon to the ace.The traffic from different known sources is going over an transparent proxy into the internet. Based on the source address the traffic should be loadbalanced to different severfarms.My conf...

I'm having some issue with sites being timed our connecting to remote file servers when CIFS AO is enabled in 4.1, the problem goes away if we disable the WAE or the CIFS AO. I'm also noticing some major slow down on my CM since upgrading. So I'm w...

Hi,I configured ACE redundancy with ACE 4710 devices.I defined admin context in HA.one on the ACE is - Active and the other device is standby HOT.I checked the configuration synchronisation and everything looks fine.The problem is ,once i configured ...

Hello,(short version...)In a multi-context ACE module configuration, is there a reason why we can't access a virtual server using it's virtual IP address (VIP) from machines located in the same context? It works fine from other contexts, but I can't...

I am preparing to install a WAE in the datacenter using WCCP for redirection of traffic to 1 of my networks on a point-to-multipoint frame relay network. Where things get foggy is the WCCP server install on my "router" which is actually 2 6509's whi...

Hi,I've been testing redundancy of a pair of ACE 4710 Appliances (A3(1) software) in our lab and run into a peculiarity in the FT configuration. I configure the FT exactly as in the configuration guide and it works perfectly as long as I use a cross-...