Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Problem description:We are running NAT overload over two Sub interfaces, each with another VRF. When the customer wants to start an ftp or another TCP session, the NAT translation doesn't run on both interfaces simultaneous.When the first ftp transmi...
Hi All, I have configured the Cisco 6509 to send all the snmp traps to the NEtact snmp server. I get the config change traps being sent to the server. But when I plug and unplug my laptop to a Gigabit interface I do not get any traps. I am able to se...
Hi All, I have configured the Cisco 6509 to send all the snmp traps to the NEtact snmp server. I get the config change traps being sent to the server. But when I plug and unplug my laptop to a Gigabit interface I do not get any traps. I am able to se...
Hi All, I have configured the Cisco 6509 to send all the snmp traps to the NEtact snmp server. I get the config change traps being sent to the server. But when I plug and unplug my laptop to a Gigabit interface I do not get any traps. I am able to se...
probe tcp LDAP port 389 rserver host one ip address 10.14.12.30 probe HTTP probe HTTPS probe ADAM inservice rserver host two ip address 10.14.12.35 probe HTTPS probe HTTP probe ADAM inserviceserverfarm host ApplicationServer failaction pu...
Hi,None of the internet Ip addresses assigned to the interfaces are correct. I have just given fake ip adresses as this is a public forum. I have seen to it that there is not ip address conflict or any other issue with the IP addresses.the NAT works ...
Hi Syed,There is: class-map match-all FTP-PASV-CLASS match virtual-address 10.10.10.1 tcp eq any Why there is any? In basic passive config there is like this:class-map match-all FTP-CLASS match virtual-address 10.10.10.1 tcp eq ftp Could act + pass...
Hello Syed,Thanks for the clear explanation of this.This is what i was looking for Just wondering frm where did you got this info as i serached the whole cisco site but did nt got this information there? I apriciate if you could share the link.
Hello Iftekhar,Thanks for the update,I know that I should use ftp inspect to prepare data connections, but I have not found any mentions is this supporting both types of ftp. Can you plz though a light on this where to look for active and passive? An...
