Application Networking

Hi, Looking at future proofing the network for WAAS and wondering how the network modules stack up to the appliances?If our remote sites have 2811-2851s, 2Mbit links, and around 100 staff... would you be looking at the network modules or the applianc...

I am trying to configure stickyness on an ACE appliance. I can't seem to get it to work. I have tried a http cookie and a IP Netmask and can't get it to work. When I do a show stat sticky or a show sticky database I get nothing. Attached is the confi...

we want a single vip to listen on multiple ports. e.g port 8010, 8111, 8112. there are 3 servers in the farm. these servers actually listen on 9010, 9111, 9112..how does the port translation happens and how will ace understand if request come for 801...

Hi,Need to load balance a SSL on a different port no (terminate at the server, hence no SSL module exist on the CSS) Below are the config, do I need to add additional config, i need it to be access via https://2.2.2.2/f1service f3_https protocol tc...

We're attempting to configure a Core Cluster for the WAE-612 and got confused when entering the access information for the CIFS file server that his core cluster will export. The doc is saying that we can only enter access info for 1 file server. I w...

I have 7371 which had disk00 failure. I reloaded the WAE during week end. Now I do not see the disk00 failure.. But I see RAID-5 critical when I do 'show disk details'. Everything looks normal. But does any one know how to get rid of RAID-5 critical ...

Hi !I tried to enable Traps on the ACE Module - but in case of Real-Server Failure nothing is sent out...I did the following:snmp-server host xxx.xxx.xxx.xxx traps version 2c xxxxxxxx snmp-server trap-source vlan xxxsnmp-server enable traps slb vserv...

WAAS Mobile 3.4 client fails to install on a laptop with fingerprint authentication with the message relation to "incompatible филе". Деталс аs follows:Authentication ManagerBIOLSP.DLLVersion 1.4.0.99Any ideas how to sort this out?ThanksDG

Hi,Does ACE support IPv6? Are there any limitations on deploying ACE with IPv6? Thanks,Nitesh

we are going to use one arm mode to deploy our CSS 11503, please find the attached picture:1. should the CSS connect to distribution switch (layer 3, Cat6) or access switch (layer 2)?2. for the servers need to be balanced, do we need to change the de...