Application Networking

Hi,A newbie question :-)How can I see a real source IP address of a sticky table entry on ACE running 2.1.1 code?If I do "show sticky database" I see a hash value, but not IP itself. In CSM the command shows the source IP, but not on ACE....Thanks!Da...

This is going to sound pretty general at first, but is there any way to do active/active balancing between two datacenters using Cisco CSS's? let me explain that a bit further.In my case, I'm not necessarily interested in having clients load-balance...

hi all,my 6513 (on slot 11 port 26 )is connected to Proventia (ibm) mgmt port;and i have installed SiteProtector on other Server, i can ping, but not access thru http, my boss told me to config rspan or span and find that port number of which is t...

Hi All,I am running BOX to BOX CSS redundancy. When the CSS 1 goes down CSS 2 will take over the role and everything works as it should be but after some minutes the services die for one to two minutes. Then the come up again and remain stable. And ...

Let me prefix this by saying that I've been working with Cisco on this for 2 weeks to no avail. I have a 6 WAE Devices(5 WAE-612-K9's and 1 WAE-512-K9) out of which I can't seem to configure 1 WAE-612-K9 to work properly. To explain my configuratio...

I will be replacing 11500 CSS which are not doing SSL termination, just load-balancing SSL sessions terminated on servers with ACE 4710. On their CSS config, they were doing SSL-sticky. I understand the 4710 doesn't support SSL sticky, but can perf...

whats the equivalent command of flow-multiplier-timeout command in ACE

Hi!Is it possible to loadbalance ftps with ACE?I have an ACE loadbalancing to a pool of ftps servers. I configured the ACE to ip source stickiness (to ensure data and control channel consistency) and VIP without any port information. However I can't ...

I am testing a WAAS infrastructure with couple of WAE-512 (CM and Core) and NM-502 at edge.WCCP has been properly configured on the routers and WAAS devices. I have also configured WAFS service and this works fine, however other application optimizat...

I am using the HTTP probe shown below. When we shutdown our backend application the server is returning a 500 response code to the client but the CSM does not remove it from service.probe TEST http request method get url /test/engine expect status ...

Hi all,we have a CSS 11503 and two servers connected to it.We need to perform the following configuration:when traffic is directed to an URL (correspondig to a content VIP) that contains "/string1" or "/string2" or "/string3" load balancing with sess...

hi i want to find if CSS can meet this requirement.-application expects CSS loadbalancer to send http packets to specific nodes (IIS servers) based on meeting specific requirement, by inserting and reading cookies on the packet header.Equivalent F5 -...

Customer has a standalone CE (7326) and all traffic is redirected to an Ironport device. The Ironport device prompts for a username/password, once those credentials are correct, the user can view webpages. Is there a way to enter a username / passw...