b_ferguson
Beginner
Beginner
Member since ‎08-10-2006
‎11-30-2022

User Statistics

  • 166 Posts
  • 0 Solutions
  • 25 Helpful votes Given
  • 15 Helpful votes Received

User Activity

CUBE configured with dial-peer pointing to IVR system, calls originating from outside users that don't have the same carrier as the provider for this SIP trunk work just fine and their payload is showing as 101.  only calls originating from the same ...
cisco codec pro, have a screen in the front of the room and a screen in the back.  Is there a way with a ui extension / macro to change the source so if the user wants to change the source, they can?  i've only seen a way to change it within the code...
I've seen other forum posts regarding this topic but I can't seem to get this to function properly.  I have a customer that uses a dictation company where they call a number, leave a message for what they working on and either hang up or enter a key ...
So I have a question regarding the netflow direction.  All the guides that I have seen only show the input direction.  Are you suppose to create 2 flow monitors, one in the input and one in the output?  Could someone please enlighten me on this?
Every 3 hours we are receiving a warning message stating that "The device is about to disconnect from the network" and then roughly 10 mins later the message states "The device is operational and ready to partcipate in the network".  I can't seem to ...
Community Statistics
Member Since ‎08-10-2006 05:22 AM
Date Last Visited ‎11-30-2022 12:15 AM
Posts 166
Total Helpful Votes Received 15
Helpful Votes From
Helpful Votes Given To