Application Networking

Hi All,Is it ok to simultaneously enable the DNS and DHCP server of the CNR on one machine. Our CNR is currently used as a DNS server which is load balanced behind a CSS11506. We want to enable the DHCP feature. Will there be any issues with this set...

Has anyone had any problems with using SLB and a real server that is a vmware guest OS? I've recently configred IOS SLB on a 3725 router in my network and the server farm config that has physicals hasn't had any problems, however my other serverfarm ...

hi i need some help about checksum field in lsa when a router receives more than single lsa of same type from the same advertising router, it follows the following step in selectionsequence number if the sequence numbers are same then check the check...

Good morning;I hope this is the right forum so here it goes. I have an ACS server v4 that keep hanging. If I try to restart the server (CSAuth), the service hangs and the only thing I can do is restart the server. Is there something I can do to fix t...

Hi everyone,I have a question how configure Router I/F to avoid redirection loop.I understand Router and WAE must not be attached to the same segment to avoid redirection loop as written in the Quick Configuration Guide.However the sample configurati...

Hi all, I have just installed the NIST software and it comes up fine, but I was wondering what I have to do to get it to recognize all of my network interfaces? I have a total of 5 with an on-board interface and an added 4-port NIC installed. Cureent...

We would like return traffic from one group of servers to follow one default route, and the return traffic from a different group of server to follow a different default route.Will the CSS allow this configuration?Thanks!

Hi,Can someone send me a link or any Doc which guide me how to use multicasting on CSS to elimenate unnecessary boardcast.Regards,

Hello, team!I can't find any information about configuration GSS DNS forwarding feature .I config answer type NS for IP of my DNS. Is it all or I must config anything more ?If you have any links, please post it.

Hi All, We have installed a css 11501 to do simple http redirect load balancing. Things seem to be working, but there is one problem. Http traffic doesn't seem to be able to leave the NATed net behind the CSS. Meaning if you browse to the redirect se...

Hi, I'm wondering what you guys recommend for boosting performance on a css-11506. I understand that adding an additional scm will only help in terms of redundancy since a second scm will run only in a passive state. If I don't need any more network ...

Hi, I am unable to telnet to vip address 10.19.17.2 port 80 on CSS from the box pluged into vlan 112, Am I missinfg any thig in my config below? I can telnet to the actual server 10.19.17.1 ----- service WEB ip address 10.19.17.1 keepalive type tcp k...

Hi,we have recently added a Application which is doing many DNS Requests.So there are about 60.000 UDP DNS Flows in our flow-table and ran out of free Ports on our Group.Our Configuration:We have serval Applications(Http-Proxy, Mailgateway, Ftp-Serve...

Hi,Can i assign multiple certificates the the same VIP and virtual server? How will the content switch select the right certificates. Suppose i have two webservers http://www.webserver1.org http://www.webserver2.org. I only have one public ip add ava...

Hi All,we're trying to enable DHCP on 2 Cisco CNR that are load balanced by a CSS11506. My immediate question is, is this feasible? The two dhcp should be configured with the same address pool right? how can i ensure, that the IP addresses leased by ...