Application Networking

HelloI have ACE running in the Bridge ModeI have server and client sharing the same vlan. connection between client and server works fine. But is it possible to make Loadbalance the connection from server to server in the same subnet using VIP as a d...

Hi Everyone, I need to inform the operator the procedure he needs to make to power off the SSL-SM Module. I want to avoid give him access to an administrator account, but I can?t see another way. What?s the correct way to shutdown this module ? Any t...

Hi folks,Will CSS match if the header is lowercase ie. msisdn:TIAAlan

Hi i was wondering if i can configure the flow-timout for example udp port 53.And this on a CSS 11500 software 7.40.

Hi,Can anybody tell me CSM in 6500 series can be used in place of CSS 11500.If yes what are the major differences between the two.Best Regards,Rahim

Hi there...having some issues getting my head around this intermediate SSL cert stuff. Can't seem to find any good config info for installing. I have the cert issued by verisign, but cannot figure out how and where to install the intermediate one, le...

Our network design consists of two PIXes in front of the CSS (client side). The two pixes are different one another.The first CSS has the first PIX as the default gw, and the second CSS the other one. We also use the bridge mode setup.The default gws...

Hi. I have an application which makes an IP Socket connection between Point A and Point B. What I want to do is put the 11500 between these two points and configure it as follows: If the port is available, route using a persistent connection to Point...

Hello,i've wanted to configure Stickyness via SSL Session ID.I coul'd not find anything in the docs how to do this.Is this feature not supported by the ACE?Sven

Here are two problems I am currently experiencing: - IP failover with no apparent outage at primary site- Unreliable GSS proximityHas anyone experienced any of these issues with a GSS?Please advise what you did to resolve the issue. Thank you so much...

I am trying to figure out a way to automatically initiate a stream request behind/ or form our content engines so that I have a way to actively monitor the health of the entire CDN. My thought was that this would provide a mechanism to provide some s...

Hello,We have a need to load balance 3 FTP servers. These servers are reached only from a single client IP which is a database server. The FTP method that is being used is currently passive. Our configuration is currently unidirectional, ie, the FTP ...