Application Networking

Hi,I'm deploying Cat6500 with CSM-S & FWSM modules. Doing bridge mode for the CSM (and FWSM will do the inter-VLAN routing upfront). There are 3 (three) different applications (Vidiator, BEA & XIAM) placed in the Internet VLAN. Each application consi...

See attached two files showing the problem and the config file.=========================================zvtllagx001>sho ip slb conn client 172.31.135.62 prot vlan source destination state --------------------------------------------------------------...

Somewhat off-topic, and perhaps not the right forum anyway, but wccp is part of content networking, isn't it?Does anyone have experience of integrating Juniper's WX/WXC products with WCCP ver 2. The reason I ask is that Juniper's documentation says t...

When trying to passive sync the startup-config to the back SCM the CSS reports and error.The image and boot config sycronised ok.Is this a know problem and if so is there a fix.The master SCM has a GIG uplink to another device where as the backup doe...

Hello, I have been posed a question by a SAP application team - they wish to load balance from a SAP application server, targeting URLs.The SAP server will target URLs, resolving to the CSS - the CSS must then load balance these requests across other...

Getting a lot of bypassed requests. Nearly 30 percent of requests. Most show up as "Packets bypassed, no pending connection: " Can someone provide a little more detail what is meant by this.Thanks.

Hi All,I need a big help on how to integrate FWSM & CSM-S in Redundant Cat6500(with one FWSM & CSM-S and Sup720 in each Cat). I'm NOT trying to load-balance firewalls. The Firewall is used to filter traffic between VLANs in the CAT6500. And the CSM i...

I got this messages in Juni and upgraded to 4.2.4. Now I get this messages again occasionally in bursts during day and night. I have IOS 12.1(20)E2 in a 6509.Do any recon this?RegardsMats

Hello,i've a big project on my company.There shoul'd b e set up about 8 Servers, with 14 virtual Servers on each machine.Each virtual webserver shout get it's own IP Address.But this is not the end, they would need more virtual Servers over time.So t...

Hello,We are using a KAL-AP keepalive between GSS and CSM for our global application. One problem we are facing is that the KAL-AP messages (UDP 5002) for VIP status are sent from GSS in one data center to the CSM in another data center. However the ...

We've been having some strange behavior around 6:30 in the morning every weekday lately for our 3 LB'd server behind our CSS 11151 (v 5.00 Build 610s) with lots of up/downs on our keep alivesOur network config is a pretty standard (a relative term) t...

In our lab I'm trying to get a CSS11503 with Gig over coper ports (SCM-2GE) to talk to a cat 4k fast ethernet port via cat5 straight-through. But no luck. Do those ports speak only with other Gig over copper switch ports? Or is there a way to get it ...

Do you know if the CSS1150x?s are compatible with the Rapid-PVST+; 802.1w, variant of STP?