Application Networking

Hi,I have 4 GSS installed in the network that load balance users to 3 data centers and in each of them I have a CSM module. The KAL-AP protocol is configured between all GSS and all CSM in order to retrieve the load value form each site. On the GSSM ...

HiThere are two sql servers to be in active/backup mode.The users' requirement are:1. The csm should direct all traffics to server1. When server1 is down, it should direct to server2 and stay with server2. 2. Even if server1 is back, it should still ...

Hi,is there any way to force faiover switch from standby to active after crash of active CSM module (preemption was off). I've seend in docs "ft active" command which is not available on CSM with 4.2(1) software.Is there any wahy to switch from stand...

I have a couple of general questions about ACNS operation.In an ACNS deployment with both pushed (pre-postitioned) and cached (on-demand) content (i.e. CDN and transparent proxy, say) if content for a channel has partially been distributed overnight,...

Hi GillesIf I NAT the private IP addresses of my backend servers to a public IP address for the servers to access the internet. Can I use the same VIP address for the clients on the internet to access the servers? I suppose that this is possible. Cou...

When Cisco explains their IOS SLB feature they often use the term connections. What constitutes a connection? I assume a connection is a TCP/UDP flow. The scenario in question - if one client IP is communicating with the virtual server IP would the l...

Dear allI want to buy a CSS, I will load-balance 3 server.I want to sure that: When 1 server error, CSS will not balance to this server.And When this server is fixed, this CSS automatic balance this serve( not manual).Can you help me this case?Thanks

HI, I have a customer who wants to make use of the CSS for SSL offloading. PReviously we have always received our certificates in .pfx format but this is in .cer. Basically how can I get this on the CSS, do I need to create a .pfx file ?cheers,Mike

Hi all.My Content Engine 7305 doesn't have a RTSP licence.I set it in proxy mode.And I don't know what it do if a RTSP request ?It will stop this request or it will permit this request without caching.Plz, help me.Tran Chung

HiAm trying to set up the CSM to send SMTP mail when a probe fails but it doesn't seem to be working at all. I have tried the example script but this does not work in our environment, even if I do put in the EHLO that is required.Basically I think th...

Hello,I need to do some HTTP keepalive based on the http page itself (no error code returned by the server).With the CSS we were able to do it because the css was doing a checksum of the http page. So when there was changes the service was considered...