Application Networking

Hi,I have a CSS 11501 loaner on the way from Cisco, but was hoping to ask a few questions ahead of time. I am relatively new to this, so bear with me.I have three offices connected via a VPN between two pix devices. Local users and anonymous web traf...

Dear AllI'm configuring transparent-caching as in the attached configuration, still it is not working.any advice?When a client try to connect, i have a flow bilding between the client and destination (shown by show flows), but i'm not able to find an...

Hi,some of our users using Opera 8.51 have problem with out content behind SSL module. I've managed to google that the problem is lack of support for TLS 1.1 on our side. Does anybody know when it is planned if software (latest 3.1 release says nothi...

Hi,we are looing for a solution with cisco CDN (ACNS5.x) and content delivery to Set top Boxes (ACNS Export). Also a customer asks which e-learning systems/vendors are capable ti integrate in Cisco CDN(ACNS5.x)?Which STB vendor(s) are supportet by Ci...

We have several small schools who connect to our WAN via ISDN. All CE's have been configured to use the proxies in our WAn Centre via the outgoing proxy settings. However on integrating the CE's into the school's network, we are finding that the serv...

I noticed that the CSM module uses different time/date settings than the router.Is there a way to synchronize the CSM's clock to the router.Thanks,Attiladplexdmz-6509-1#sh clock11:29:17.246 CET Fri Feb 17 2006dplexdmz-6509-1#sh mod csm 1 probe real r...

1) What happens if all 3 cache engines fail?As far as I understand all traffic is forwarded directly to the Internet.Is there a way to block the normally redirected traffic?2) Do the "redirection hash table" on the 2 switches get syncronized?3) Are t...

Hi, There: I checked web site doc. I found there are some redundancy configuration for in-lin, did anyone try one-arm redundancy configuration?Thanks,

I have a 1503 CS. I would like to know If I can use Advanced-Balance Arrow-point cookies in our environment. We have the ssl being done on the server. Will the following work: content t2p443 vip address xxx.xxx.xxx.xxx protocol tcp port 443 add servi...

Is it possible to create an slb policy using a single SSL Virtual Server that will redirect based on url, to a different port on the serverfarm. I've got a virtual server configured now without policies listening on port 443, which flows to a serverf...

What would cause users to loose session connection on the 11500 series switches.Arrowpoint cookies are been used.

We are currently using the following configuration for a number of situations on our 11501 (No SSL module). content webapps443 protocol tcp port 443 balance leastconn vip address 192.168.2.106 add service webapps1 add service webapps2 add service web...