Application Networking

Hi,I have attached config, network diagram herewith. We have two CSS 11506 configured one-armed mode. We are using the load-balancer serving for mobile subscribers who uses WAP to download data. Things were working fine, but in current festive season...

Hi all,I have the attached config where basically I want to have 2 VIPs so that for port 80, it just forwards to the servers. For 443, it should offload the SSL and send it cleartext to port 7778 (for VIP 206.83.206.68) and to port 7777 (for VIP 206....

Hi,My user is experiencing some issue while attempting file transfer with servers that is loadbalance by the CSM.The situation is as, when my user try to copy files that are less than 100mb, the whole process is completed successfully. However if att...

Hi, I am attempting to perform web caching with one 7325 that has two interfaces connected to two different VLAN's on the same 6500. Although I currently have this working, I ran into lots of problems getting it to work and don't really have a good r...

Hi,I'm experiencing some strange behavior having configured cookie stickiness. In the request towards the CSS I see a cookie. The request is not forwarded to the correct server but to another server. Normaly this is working except if we are having so...

Dear All,I have a problem with content engine 511 authenticating with LDAP server. I am using Lotus notes LDAP server to authenticate with content engine but it doesn't work. Anyone has try with LDAP before? Please advice. Thank you for your help.Reg...

Our customer uses your product(CSS) for balancing loading over several servers where some website is working. This website requires login for users. To handle user session between users requests Tomcat session mechanism is used.But sometimes while wo...

In the attached config, is possible for the css to have content rule that does not at least contain the same port as the service rule. This does not seem right without some special configuration.

Hi,I need some help to troubleshoot a problem I'm having. I have a CSS 11000 and I should start by saying that I have a very basic knowledge on how to operate. On the CSS I'm getting the following error:DEC 21 10:20:35 5/1 6245 IPV4-4: ARP: could not...

I have a scenario where I have the same two servers (s1 and s2) being load balanced in two different content rules. One content rule is doing sticky based on an arrowpoint cookie, the other is using source ip as its sticky method.My question: Is ther...

Hi,I have CSS 11501 V7.50When I sent to VIP IP bigsized packet (65k) I get no response.First, I tested with ping.I sent ping sized 1600. Request time out.Then I sent ping sized 1473 request time out.When I sent ping sized 1472 I can got request. (On ...

We have the follow configuration:ip slb serverfarm MMS_BOX nat server failaction purge probe MMS_PING ! real 10.10.1.39 weight 100 faildetect numconns 3 numclients 1 inservice ! real 10.20.1.201 weight 20 faildetect numconns 3 numclients 1 inservice ...

I am running two CSS 11501's (running 7.40) attached to two Catalyst 3550's (running 12.1(19)EA1).I have converted two of my interfaces from bridging to trunking on my CSS. There is an in-built bridge loop for network resiliency. The CSS's are connec...

On a CSM v4.2(3) on a 6509: I'm trying to make the real servers have names (like on the local director) instead of IP addresses:VOC-SW15#conf tEnter configuration commands, one per line. End with CNTL/Z.VOC-SW15(config)#mod csm 4VOC-SW15(config-modul...

Hi,I have a CSM+SSL module in a 6506 switch. I can'nt get the CSM and SSL module to communicate at the admin level.On the 6506 I have created a vlan and vlan interface to communicate with the SSL.interface Vlan60 description : Management Vlan for SSL...