Application Networking

We have configured two GSSs to be authoritive for a domain, Can you tell me if only the primary GSS (GSSM) responds to DNS queries or do both GSSs respond. Or is this dependant on how the intermediate DNS server is configured ?

I'm sorry if this appears twice, but I thought I had sent early and now cannot find.I have looked at the documentation on how to set up redundant CSM but all seems to use full IOS. I have a CatOS hybrid system and just need clarification on one point...

I just configured two web servers behind a CSS11501 box to box cluster. Both web servers has two interfaces active, the secondary interface on both are on a private 192.168.1.0/25 network so they are on the CSS's LAN.What is a bit of an issue to us, ...

Hi,My customer just bought a CMS for their Cat6 to load balance a number of servers. The easiest option i have, i guess will be the bridge mode. But I've one concern, which is my customer environment is having 20-30 plus client VLAN, do i have to cre...

6500 SSL Module w/CSM: We run an application that tunnels rtmp protocol through ssl. When running traffic through the ssl module, throughput is quite slow. When we use another non-cisco ssl offload, throughput is high. Or if we handle the ssl directl...

HiI have the need to use different default-routes depending of the Outgoing VLAN. I have seen taht an approach is PBR. Is there a way to do a virtualisation of the Loadbalancer like "vrf" on the routers ?

We need squid cache to communicate with multiple routers. The Squid is working fine with WCCPv2, but, as far as we can see in squid conf, there can only be one wccp2_router directive defined.When we use wccp2_router the multicast IP address 225.25.25...

My current configuration, which is working fine:A CE-565 running 5.3.3. It also running the integrated WebSense system. My users are redirected to the CE via WCCP. Caching is enabled on the CE.Now I need to enable ICAP for anti-virus on the CE. I'll ...

HiI have a 6509 with a CSM in slot 3. Does anyone know how to clear the configuration of the CSM independently of the switch configuration.I have tried 'clear mod csm 3 linecard-configuration' but having reported that it has cleared the config, it th...

Just got the CSM installed and was trying to upgrade the code level to 4.2. The configuration guide for 4.2 says you can upgrade via sup-bootflash, pcmcia card or tftp. Haven't tried tftp yet, but here's the problems I'm having so far:The syntax for ...

I just replaced two servers which were behind the CSS LAN with two brand new ones. The old servers were never actually in use, but services and content rules were created.I entered the same private IP addresses for the new servers, 192.168.1.11 and *...

Hi,According to the documentation, if the command:- proxy-protocols transparent default-server- http proxy outgoing host a.b.c.dare used, content engine forwards intercepted http proxy-style requests to the corresponding outgoing proxy server, a.b.c....

Hi,I've created a WMT multicast station on my CE for live streaming splitting. Based on sniffer traces, the CE can receive both unicast and multicast streams from my WMS server. It also multicasts the unicast or multicast stream from the WMS server t...

Hi ,could anyone tell me what the command is on the CE510 to bypass certain URL's from being cached.The device doing the redirection is a 3750 SMI switch. I know with the routers it is possible to create an ACL that can influence which sites to be re...