Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've posted about this subject before because its pretty vague and I've yet to speak to anybody who's got it working in the UK.Basically I have some channels configured that suck in some video's from a webserver (that doesn't have streaming media ser...
I'm new to configuring CSS. I have been able to do simple load balancing, redirects and SSL, but I can’t' seem to get all three to work together. I have looked at all the docs I can find on Cisco's site, but I haven't found any good examples. What I’...
I have LD416(3.1.4) and configured 1*VIP and 2*Real server. looks it takes about 30 seconds to switching to the other real server when one of failure. Q) How can I reduce the the convergence time?Thanks,
If I manually suspend a service using the suspend command, is it true that the CSS behaviour is different whether the service is in a Layer 3,4 or 5 content rule ? I read that if the service in a Layer-3 or 4 content rule, existing sessions continue ...
Hi, If i upgrade from 4.1.2 to 4.2.1 and have active/standby state, can I just follow the instructions for hitless upgrade and after that invoke the command hw-module csm x standby config-sync without any other change? Regards Mats
Hi,Two switches have one CSM each in redundant mode. Are the failover packets tagged with a higher cos (5) as with the FWSM module?Thanks,Best regards,Pascal
Currently, I am running a cisco 11501 (soft 7.40) with a SSL module configured for front and backend SSL. layer 5 filtering and OWA is working fine except when I try to use a URL link embedded in an email. The URL changes .. for example from (email u...
i,I recently bought a Content Switch Service (CSS-11100) and I tried toplug the interface e15, which is in 'bridge vlan 15', on aCatalyst-2924XL Fa0/15, the problem is that the interfaces on bothswitches are down:CSS:# sh circuits allCircuit name Cir...
Cisco,Please review the attached files. You will see the arrowpoint cookie is injected into the 200 response in the good.txt but not in the bad.txt. Our users continue to be timed out due to issues with arrow point cookeis. Please help. This is simil...
Hi,I have a problem with client authorization on a CSS11501. The client auth worked on a SCA 11000 and we're trying to migrate to the CSS but as soon as we configure ssl-server 1 authentication enable and the ssl-server 1 cacert xxx the webpage stops...
If I manually suspend a service using the suspend command, is it true that the CSS behaviour is different whether the service is in a Layer 3,4 or 5 content rule ?I read that if the service in a Layer-3 or 4 content rule, existing sessions continue t...
Having a hard time to get a load balanced redirect working on the css.What i want to do...VIP accepts the client request and instead of forwarding it simply to port 80 on the backend it redirects it to "hostname.domain:50000/dir/".I have read the two...
Hi, I was wondering if someone got CSS1150X with SSL accelerator working with wildcard SSL certificate. We have 10+ sites we would like to enable SSL and figured wildcard certificates are way to go based on the cost. Specially, since most of the wild...
We have a pair of CSS11503s with two SSL modules in each chassis. We balanced our numerous SSL VIPs across them based on CPU. In other words, we put some VIPs on one module, some on the other until we had both CPUs about 70% utilization at peak hours...
