A Cisco CSS 11052 ids was picking up ping sweeps and we realized the load balancer was doing it. It was sweeping for 10.16.x.x subnet. I need to know why it's doing this and if there is a way to and turn it off.Thanks for information you may have.
I only found the documentation for critical services "scripted, redundancy uplink and local" in the advanced admin guide Rel 7.2--snip-->scripted - the priority changes to 0 when one service in the scripted group goes down. redundancy uplink - the pr...
Hi All, I tried to force the TTL of cached objects ussing rule and templates on a CE-565 but the object remain cached enven after the ttl expiration; here is the configuration:http cache-cookieshttp cache-on-abort enablehttp proxy incoming 80 http...
Hi,my question:Is it possible to set up two 3550 with HSRP, and to have the HSRP logical address to be the one ip address to communicate to a WCCP cache cluster ?(I'm aware of this: "This software release supports the connection of only one 3550 swit...
Hello all I am new to the 11503 switches and would appreciate some help with the config. We are replacing our LD417G's with these switches and because of our current DMZ setup & ip addressing i cannot setup the 11503's in router mode. What i have don...
Hi,My CSS 11501 is connected to 2 Server using port 1 and port 2, the 3 port connected to the firewall.I've keep getting as below on my log:JUN 12 01:38:24 1/1 130 NETMAN-2: Enterprise:Service Transition:Server2-80 -> downJUN 12 01:47:59 1/1 131 NETM...
standby CSM go hanging. without log message.and no output for CSM command that "show mod csm 9 vser, show mod csm 9 real" and can't connect vserver on this CSM...
We are trying to load-balance print server connections between 2 MS print servers. When we try to connect to the VIP address, we get a Path not found error. However, if we direct the path to the actual name or ip address of the print servers (not the...
I have started using NBAR on the routers and think it is good, but it needs to have a few enhancments.eg how about SAP traffic, I know the ports are variable for SAP but usually between 3200 and 3210 ..it would be good when defining the ports, if we...
Hello to everyone,Im trying to put forward a proposal for a much needed upgrade of our companys infrastructure and wanted to pass it through your expert eyes first to make sure no major mistake is being done, one that would cost time & money...We...
I have separate VIPs defined for balancing dns and radius. Both services are being balanced behind the CSS between two servers running both services. Is there a way, using source groups, to have the outbound dns udp lookups go out the associated dn...
I am looking for a way to monitor the health of servers by checking https as well as the existance a a web page on the server. I have been able to set up my CSS to check one or the other but have not been able to do both.Does anyone know of a way to...
Hi All,We are having a few problems with 2 CSS 11000's we have.currently they are running 5.00 build 208.What version should we run? I am _very_ new to CSS's so bear with me.Cheersdave