Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are going to implement a small (2-3 APs) wireless network and we wanted gust to have access too. My question is how do we implemetn the guest setup and separate that accessf rom our network. How does the 526 do it. Do we need a separate internet a...
I have a pix 501 that has been working. Last night i started to loose connection and found that I will get an outside address for a few seconds then it will be gone. It will auth (pppoe) after 30 seconds and will get an outside address then will loos...
I have a PIX (v6.2)firewall and that has been working fine. A few day ago it is not getting an external address. I connect via DSL using pppoe. I know the dsl is up because if i bypass the PIX I can connect. I can connect briefly if I change the aut...
When trying to VPn using the Cisco vpn 4.0.1 client that is behind a PIX 501 I cannot connect. We know that the VPN is working fine because we tested it . Is there some commands that is needed to be added to let VPN go through the PIX?Thanks in ADvan...
Thanks for the reply. I did see this before I just cannot understand how creating the guest vlan will segragate the guest connection from our network. I just need more explanation on how the guest connection would not be able to access our data netwo...
I think you will need to do multilink so the 3 t1 will show as one. Even if you can make this work without multilink how will the packets know what path to use going outbound and inbound you might send some outbound to ser1/0 and getting inbound to ...
Found the problem it was my DSL modem. Although if I directly connect to it works fine and I can browse the internet. That's why I started looking to my pix as the problem. I do get the " limited connectivity error" on nic card when directly connecte...
Thanks for the response patrick.I have int eo on auto right now. I will try to set it maybe 10baset and see. Unfortunately I do not have access to the DSL modem. Thanks for the link.
