We have a localdirector sitting in front of two real servers(IIS).Load balancing works fine with both backend servers connected, and show real produces:# show realReal Machines: No Answer TCP Reset Da...
I want limit client to server and I try use NQL w/ acl.If I enable acl then any traffic will drop(clause permit before acl enable).Anybody have samples or tell me how to config Tks!I want vlan3 can access and vlan2 can't!************************* INT...
I have a CSS configured with public (203.x.x.x), DMZ (202.x.x.x) and private segments (172.16.x.x).Configured reverse proxy to internal servers 172.16.3.3 and 172.16.3.4 using VIP 202.x.x.10. This is fine.Now, we want also direct access to the inter...
I have several sets of CSS's running in box to box redundancy running version 5.03 Build 15. My question is what causes one CSS to out of the blue go backup and the other become master? I've had this happen on just about all the ones I have configu...
Have tried configuring 11503 using http head keepalives but the service shows as down.Checked on the server and it is receiveing the requests but passing back "internal error" and "error parsing the get/POST data stream".If I configure the 11503 wit...
HelloWe have a CSS11503 and two Microsoft ISA Server 2000 that work as Proxy. We would like to place the ISA Servers behind the CSS so that Client's proxy connections (port 8080) are balanced. It seems to work with navigation.Now we are trying to mak...
hi,we're having trouble with a CSS11051 v5 build 105:the CSS is plugged between the servers and a pix 515.the pix is plugged onto Internet.when a request is sent from Internet into a server,the server gets the request and replies.but apparently, the ...
Hello. Anyone knows how to extract the cert from IIS v5 server. Do you know how to get the cert from IIS5 to work with the CSS? I belief the exported cert from IIS v5 has the private key in 1 file. thanks
I hope that someone can help with 2 simple (i think) CSS questions.1. When configured properly for load balancing, should the CSS round-robin between servers or will it continue to use only one server until triggered by some event or parameter?2. If ...
Is there a way for my CSS 11052 to send an SNMP trap to my NNM console when a failed keepalive removes a service from the availability list?thanksBruno
Dear All! Is there somebody who have experineces with SLB for SAP portal? The main question is : Which sticknies to use: SSL or IP based? How to configure IP based, because I did not find good explanation of "netmask" parameter in sticky,stic...
HiI recently had to diagnose a problem with an LD. A percentage of people trying to connect to a website being loadbalanced by a LD430 could not connect to it. I finally tracked it down to synguard being active on the virtual ip. shutting down syngua...
It is not clear on the requirement the website about this device. For single SCA device configuration, do you need more than two IP addresses? The problem I am facing now is I have only one free ip address left. Based on what I had read so far, I don...
