Application Networking

We have received a note concerning stateful failover of the CSS series of products, where the CSS 110XX series doesn't support stateful failover, however the CSS 115XXX will. Here is the digest of the message;On 3/6, Hosting Engineering and Operation...

I have got a Distributed Director which is currently being used in the NAme Server Mode. I have got several domain names www.???.com,www.???.gov etc. Each time a client tries to get to any of these domain names I want the DD to reply always with www....

I've encounterd a problem on one of our application servers where the server process would lock up and refuse anymore http sessions. We have a setup where load-balancing occurs between two servers. We create two content rules per server, one for http...

How do I config a static or default route for the ethernet management port so I can get to the ethernet management port from remote subnets.Is there a workaround?thanks

I've tried to run MRTG against IOS SLB to get stats on the VIPs, but can't get it to work. Anyone else had any luck with this ?Anyone monitoring individual VIPs or serverfarms some other way?Simon

All virtual routers on our backup CSS are flipping back-and-forth from backup to master within 1-to-5 seconds at different times of the day. Different services are also flipping back-and-forth from alive to down during the same time frames. The maste...

Is Port Channel Supported on the 16 port card on the CSS 11000 series load balancer how should i configure the CSS if the Servers and the uplink lies on the same 6500 cat and i wanna configure one arm config???Regards

I'm doing some testing with a CSS11500 in a one-armed configuration. I need to ensure that users will stick to the same web server for a period of about 8 hours. I know this can be accomplished with sticky sourceip, but wanted to try arrowpoint-cooki...

My goal is to optimize the service keepalive frequency, retryperiod, & maxfailure parameters.1) Will the CSS setup new flows to a dying service (which is not dead yet)?2) What about already established flows... Will the CSS continue to route those pa...

Hi,I would like to seek some advice on the redirection feature (using service type redirect) in a one arm CSS configuration.In our environment, we process incoming HTTPS request and load balance to 2 HTTPS Servers. In the event that all the local ser...

Since the ACNS 5.0 has so much more thrown in to it, why hasn't SAMBA been added to allow the CEs to be seen as Windows 2000 share points? This would make a great deal of sense since with DFS and the current software deployment/update design from Mic...

How do you assign a radius authenticated user as "superuser"?ThanksTom

we have 7305 with 5 disks installed. Can we config RAID?