SPA 3201 Disconnect Tone - WAV file and tone script

[mwkidd111]

Trying to detect a POTS hang up when dialing into SPA 3201 on a mobile -- want the hook back on when the mobile cuts out.  Attached is a wave file which seems clearly to be 400 hz 0.375s on / off.  Attached is the tone scipt in SPA 3201.  Running latest firmware.  Not sure why its not detecting.  Tried for hours.  My first time at this so I thought I'd run it past here in case there is something obvious I missed.

[Howard Wittenberg]

I note that the Cisco ATA Administration Guide lists the following specifications for disconnect tones used in various countries.  It looks like the U.K. and New Zealand use a 400hz tone frequency.  Have you tried that spec?  Until you find the right specification you could always setup the SPA3102 to disconnect after a period of silence.

http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/ata/administration/guide/ATA_AG_v3_NC-WEB.pdf

The Disconnect Tone Script values for various countries

follow:

US—480@-30,620@-30;4(.25/.25/1+2)

UK—400@-30,400@-30; 2(3/0/1+2)

France—440@-30,440@-30; 2(0.5/0.5/1+2)

Germany—425@-10; 10(0.48/0.48/1)

Netherlands—425@-30,425@-30; 2(0.5/0.5/1+2)

Sweden—425@-10; 10(0.25/0.25/1)

Norway—425@-10; 10(0.5/0.5/1)

Italy—425@-30,425@-30; 2(0.2/0.2/1+2)

Spain—425@-10; 10(0.2/0.2/1,0.2/0.2/1,0.2/0.6/1)

Portugal—425@-10; 10(0.5/0.5/1)

Poland—425@-10; 10(0.5/0.5/1)

Denmark—425@-10; 10(0.25/0.25/1)

New Zealand—400@-15; 10(0.25/0.25/1)

Australia—425@-13; 10(0.375/0.375/1)