Cisco Bug Discussions

Will virtual templates ever be allowed to support zone base firewall?!?

Hi   Today I have a problem with ASA5505 which I can't access via ASDM. The error show "ASDM did not get a response from the ASA in the last 60 seconds. Please check the configuration and your connection and then try again by clicking refresh". I cou...

Having this same issue on HA 2140's running 6.2.3.9.

Hi all, please help me with this, suddenly switch hang and seeing this two logs  1.  %SUPQ-4-CPUHB_RECV_STARVE - receive queue stuck after throttling2. %XDR-6-XDRIPCNOTIFY: Fatal IPC error occurred for peer in slot this is the ios  c3750-ipservicesk9...

hey, youtube cannot be blocked on chromehowever it's blocked while using internet explorer and microsoft edge , firefox some times doesn't block too but chrome is always allowing it, so i am searching for a solution please

Has anyone seen this in versions below 3.1?

Hi, is Nexus 9000 also affected with this bug? I have N9k 7.3.I7.6 and unable to find the same command or any equivalent.thank you! 

I have a Logitech H820e headset that i have set up in Jabber. Jabber is picking up the head set and the audio test and mic test work. When i make phone calls through Jabber it goes through my Cisco phone model CP-7962G phone instead of the headset. A...

We have problem with the ISE portal, when we open a https page using firefox or chrome browser, it is not redirected to the ISE portal, an error appears in HSTS. The problem I checked on windows 7, 10 and android and don´t have solution for the momen...

The bug description says when a 'renew' request is sent this bug takes effect. Is that correct? I have a device which shows all the symptoms apart from the fact that it never got any IP addresses using DHCP, so there were no 'renewals'.

I faced the situations of CSCvg59274 whenever I exchange FAN of Cisco ASR9901(IOS XR6.4.1).After exchanging FAN,I needed reboot Cisco ASR9901.I found the article and it shows some workaround(seems not official). http://www.belpia.com/workaround-for-c...

This bug has negative effect on your WFM and your agents performance, also it directly effects your SLA with your customers  

Hello. I don´t know if this will works for all, but at least to my goes fine. I had to migrate the config to a new S370 and gave me that error. I just change the time on Wsa to a date before on May 1st 2016 and that let me charge the backup configura...

RFC3576 is supported on 8.5.140 (Using 5508 WLC ) from the docs.I can enable from GUI, but not able to set from CLI..I am however using CLI script to create Radius server and need to be able to set RFC3576.Below is CLI sequence.. Anyone aware of a CL...