This also appears to be affecting 8.3.141.0
This should be a much higher priority bug, as touching client devices you don't own is not something you should be doing, and the two VLAN approach goes against best practices.
Has anyone ever seen interference between channels as consistent as the attached screenshot? This analysis is from a 9 story residence building with HD-WLAN infrastructure. I'm trying to determine the source of this noise.Thanks.
Gateway Load Balancing Protocol (GLBP) can be used to replace HSRP in environments where you would like to load balance between multiple nodes, instead of having an active/standby pair.In order to enhance on the capabilities of Hot Standby Router Pro...
I am just curious what other people are doing in this situation. We have 2 6509's for the server farm and I wanted to be able to connect a dual homed server to both switches for redundancy.I know you can use the active/standby mode for Linux bond in...
I had the same issue with the documentation being out of date for 1.1.1. Instead of there being a "Posture Discovery" task, you have to configure "Web Authentication" and select "Posture Discovery" from the drop down box.Hope that helps,Eric
You can set the switch to automatically recover from an error disabled state, that way you don't have to waste your time logging in to the switch and shut/noshutting the port.See here: http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_not...