Cisco Bug Discussions

The message in the title does not disappear (appears only in the PCisco Bug Discussions, Cisco Bugsublisher) after upgrading my entire cluster.Only until I ran a post upgrade check on the Publisher and then a reboot made that disappear.Why do these m...

When logged into the C2960XR-48FDP-I through the Web GUI, "Cisco {{platform}} {{deviceDescription}} {{version}}" is observed in the top left corner where the actual device platform and version are expected.The same happens with the save, update, user...

HI Does anyone have a workaround for Windows 11 patch Version 21H2 that is not allowing connection to ISE 3.1 with anyconnect 4.10.05111 with posturing enabled for Windows patch checks ? Regards Nico  

I'm managing the firewall using Firewall Management Center (FMC). How can I disable the process using FMC? I cannot enter anything at the CLI other than show commands.

I encountered this bug on firepower 1140 in ASA mode, OS version 9.16.4.62. But for me workaround didn't work. Only way to successfully show access-lists was through more system:/running_config command. Be aware, because I tried to fix this bug with ...

Hi, Recently some ACI Leaf-Switches did a reset reason: reset-triggered-due-to-ha-policy-of-reset Service: fabrictrack hap resetVersion: 14.2(2f)Hardware: N9K-C9348GC-FXP I cant understand why this is happening

flash is showing unknown for switch 4500below snap, suggestSystem image file is "flash1:unknown"Jawa Revision 3, RadTrooper Revision 0x0.0x41, Conan Revision 0x1B9E

Hello!I have Nexus 5672UP.SoftwareBIOS: version 2.1.1Power Sequencer Firmware:Module 1: v4.0Module 1: v4.0Fabric Power Sequencer Firmware: Module 1: version v4.0Microcontroller Firmware: version v0.0.0.15QSFP Microcontroller Firmware:Module 1: v2.0.0...

I have a C930048P-E and it boots into a switch: prompt. I cannot force it into ROMMON nor can I tftp the following IOS file to the switch. switch: setBOARDID=20564IP_ADDRESS=192.168.0.1MAC_ADDR=84:8A:8D:E0:5C:80MODEL_NUM=C9300-48PMOTHERBOARD_SERIAL_N...

hi >>> The access point 702i disconnects automatically, and when I tracked the reason, the sys log appeared to me. Can you help me solve this problem? WLC model= 5508 , software ver = 8.5.182.0

Dears, i have a CUCM cluster running version 10.5.2.12901 and i want to upgrade on a new host with different Hostname and IP address, so i went through the procedure in cisco documents:Installation Guide for Cisco Unified Communications Manager and t...