Cisco Bug Discussions

Is anyone else seeing this bug on the Cisco 9k series switches ?17.9.4a code version

This bug has been tagged against an issue we are seeing where calls are getting stuck in queue when there is a race condition between an agent becoming available, and the queue block marking the call with a skill to stop targeting due to a threshold ...

What we can do to fix a D9854 Receiver with this bug?

Estou com um Advanced Program Receiver D9854-I Erro: rc=0x00024001 FAILED TO INIT IN PHASE 1Se alguem tiver alguma luz de como solucionar esse programa, pois tenho alguns desse Receiver com o mesmo erro.desde ja agradeço.

Today I got the same with ASR 9922, when I pull out the air filter in front of the chassis, it may touch the ejector and cause the SFC3 card to go down. The Syslog shows the card shutting down because the ejector is pressed:0/RP0/ADMIN0:Mar 31 15:22:...

Also effects 15.0.1.11901-2

nos switches Cisco Nexus N9K-C93108TC-FX3 (mode ACI, version 16.0(7e)) un échec du test RTC au démarrage, générant le fault F2421 avec la mention suivante :Échec du test de diagnostic. Raison : La tension de la batterie RTC est faible.

Hello,  Does this happen with ASR9000v2? which releases are affected? are there any work around? I don't see those answers in my bug description view  thanks  

I am running into this issue. Could I configure a fake proxy ip address and then use the ignore host field to bypass that fake proxy configuration? We do not have a proxy IP address in my organization. The proxy is transparent and is not directly add...

NCS520 is continually restarting  

Hi,I try to update IOS for my router (Cisco 2821 ).When i click to download button, i receive this message : Service contract requiredWhat can i do for upgrade IOS on my hardware ? Is it needed to pay for this ? WTF ?Thks for your advise in advance.B...

I encountered this bug on firepower 1140 in ASA mode, OS version 9.16.4.62. But for me workaround didn't work. Only way to successfully show access-lists was through more system:/running_config command. Be aware, because I tried to fix this bug with ...