CSCwi63113 - FTD Boot Loop with SNMP Enabled after reload/upgrade

[ghisisan]

I disabled SNMP prior to upgrade, in order to avoid the boot-loop bug.
Can SNMP be re-enabled after the upgrade tp v7.2.6 is complete, or does that again activate the Bug at an eventual system reload/reboot?
This is not specified in the article for CSCwi63113 .

Thanks!

[marce1000]

 - The only known fixed version mentioned is 9.16.4.57

 M.

[balaji.bandi]

yes that is what my understanding, you can disable SNMP and Uggrade and enable back.

if this is not clear - i would suggest to hold for the upgrade if no other reason to upgrade and contact for clarification.

also check always release notes :

https://www.cisco.com/c/en/us/td/docs/security/secure-firewall/release-notes/threat-defense/720/threat-defense-release-notes-72.html#c_new-features-fmc-726

[Chess Norris · Accepted solution]

This notification state that we should leave SNMP disabled untill upgrading to a fixed version.

7.2.7 are said to be released on the 3:th of May