CSCwi63113 - FTD Boot Loop with SNMP Enabled after reload/upgrade
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-28-2024 01:59 PM
I disabled SNMP prior to upgrade, in order to avoid the boot-loop bug.
Can SNMP be re-enabled after the upgrade tp v7.2.6 is complete, or does that again activate the Bug at an eventual system reload/reboot?
This is not specified in the article for CSCwi63113 .
Thanks!
Solved! Go to Solution.
- Labels:
-
Cisco Bugs
-
Security
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2024 05:15 AM
This notification state that we should leave SNMP disabled untill upgrading to a fixed version.
7.2.7 are said to be released on the 3:th of May
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2024 12:02 AM
- The only known fixed version mentioned is 9.16.4.57
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2024 12:19 AM
yes that is what my understanding, you can disable SNMP and Uggrade and enable back.
if this is not clear - i would suggest to hold for the upgrade if no other reason to upgrade and contact for clarification.
also check always release notes :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2024 05:15 AM
This notification state that we should leave SNMP disabled untill upgrading to a fixed version.
7.2.7 are said to be released on the 3:th of May