SSH can login but HTTPS not able to login Firepower 2110 chassis manag

[gantogtokhot]

Hello 

Iam facing a issue with HTTPS Management access on a firepower 2110. I assigner chassis mgmt ip address and set ip=block on the interface . I am able to ping the chassis mgmt interface from laptop and other machines. I can access the SSH in mgmt ip but can't access https we checked our firewall log and there is no deny log on 443 allowed.

[balaji.bandi]

what is the version of code running ?

can you able to post below output :

show version

show network

(is the browser complaining any security error) - you get page not found ?

i generally use pstools (from windows) check the device listening on port 443

psping x.x.x.x:443 (or you can use telnet also see if the port listening)

[MHM Cisco World]

you meaning you want to access FPR via FDM ?

if you are you run local mode ?

did you add ACL of IP accept to access FPR ?

these above two point if missing I think you can not access to FPR by FDM 

MHM

[gantogtokhot]

Hello I am sending a below result 

Cisco Adaptive Security Appliance Software Version 9.16(4)14
SSP Operating System Version 2.10(1.241)
Device Manager Version 7.18(1)152

[MHM Cisco World]

check above my comment 

MHM

[gantogtokhot]

Okay i will response you soon

[balaji.bandi]

I am looking output from FXOS chassis manager output, not ASA. connect to chassis and post.

just to be clear you looking to connect chassis manager not ASA https right ?

[gantogtokhot]

Hi here is the output, Yes i looking to connect chassis manager.

firepower-2110# show version
Version: 2.10(1.241)
Startup-Vers: 2.10(1.241)

[Gopala Krishna Chaikam]

I have the same problem on FP 9300. 

FPR-C9300-AC# sh version

    Version: 2.10(1.179)

    Startup-Vers: 2.10(1.179)

FPR-C9300-AC#

Follow the same steps mentioned in here https://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/fp9300/firepower-9300-gsg/chassis_setup.html#Cisco_Concept.dita_784db60f-f5d6-4c39-bbd7-a01d1ffaf2ba

But no luck