Hi,
I have issue in ISR4321 Router showing error of subslot 0/1 booting error.
%SPA_OIR-3-EVENT_TIMEOUT: "Subslot0/1: Timeout Waiting for SPA OIR event
Waiting for expert opinion over it.
Regards,
Prem
Can someone please explain in plain English the exact difference between a Field Notice, a Product Security Incident Response and a Security Advisor? What is the problem that each of these explain and which is higher risk?
Also, what is meant by "pot...
Failure in GETVPN between GM and Key server does not install policies, it worked well but after approximately 72 days the equipment begins to fail.
KeyServer CISCO 2921// (C2900-UNIVERSALK9-M), Version 15.7(3)M8
GM CISCO 4331 // ISR Software (X86_64_...
Hi All,Getting following error frequently and device is not forming redundancy. Its WS-C6509-E Model. As per Cisoc Bug tool, it had mentioned the following reason standby reload due to Bulk-sync failure due to PRC mismatchCSCue10556 Anyone please va...
CSCwd08703 Removal of 'write mem' and 'copy run start' commands is not explainedCisco ISE 3.2 Patch 4Found one work around: Reload cmd to generate the save config prompt and then cancel the reload:reloadSave the current ADE-OS running configuration? ...
Hi Guys,
My switch is unable to boot up, it keep stuck at POST: Thermal Tests : Begin ? I xmodem a new image into the switch but didnt work.
switch: boot flash:c2960x-universalk9-mz.152-6.E.binLoading "flash:c2960x-universalk9-mz.152-6.E.bin"...V...
Confirmed on Cisco Secure Client version 5.1.0.136re: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCwc70093 The tunnel security reinforcement on Linux upon virtual adaptor detection impacts later versions as well. I've tested this on a Cisco Secur...
I have an Expressway-C cluster of Four servers , running version X14.0.5 The one of subordinate server is giving a Error. Application failed: An unexpected software error was detected in smartlicenseget[31986]: unknown reason. Is this version affecte...
I would like to understand this issue better.https://bst.cisco.com/quickview/bug/CSCwc95388So When the C9300L uplink is connected to any other router with 1G SFP, is the link status down only in the other Router, or is it down in both Cisco and the o...
This also still impacts Jabber version 14/ is still present.We tried a temporary workaround switching to a network that has it's primary DNS reachable, even if this is an Internet connection not corporate LAN, the JVDI agent on eLux is established, t...