C9500-40X ERPSAN and local SPAN: use of same source ports possible?

[moritz.orphall]

C9500-40X: ERPSAN and SPAN: can a configured ERSPAN source session have overlapping sourde ports with a local SPAN session?

Best Regards!

[Edson A. Hernandez]

Yes, you can configure the same source interface in many sessions without overlapping, the only restriction is with the destination, that can only be assigned to a single session

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/17-9/configuration_guide/nmgmt/b_179_nmgmt_9500_cg/configuring_span_and_rspan.html

**Remember to support with a like to keep the community active***
**Please, if the information was helpful, mark this answer as correct.***

[moritz.orphall]

Thanks for your answer. The document refers to overlapping source ports combining SPAN and RSPAN (L2 Barrier) --> in my case i would probably need to configure local SPAN and ERSPAN (L3 Barrier) together.