Cisco Catalyst Center

DNAC - Unique device report / count

Is there a way in DNA Center to provide a total device count where switch stacks are not counted as 1 but as number of members. So if I have 2 stacks of 5 members each the count would be 10, not 2. Thanks

DNAC connexion WebGui and SSH refused

Hi, I can't access to the interface of my Cisco DNAC; I get a "connection refused" error.When I access it via Maglev through its CIMC interface and run the command "magctl appstack status | egrep 0/", I get the error:"The connection to the server 127...

How to move in Catalyst Center one switch from one container to anothe

I have Catalyst Center 2.3.7.6 and I´m struggling because in many cases I can´t move switches from one location to another, what I have done as a workaround, it´s this, delete the device from Catalys Center then rescan it and move it to the new locat...

Cisco DNA (Catalyst) Center fix network setting error

Hello.I am working on Cisco DN3-HW-APL Server. After setting up as Standalone, via the maglev-config wizard step. The enterprise IP address, i configured 10.60.x.x was reachable via ping and i can access the DNA center via web. I shutdown the server ...

Midplane backplane Architecture of the chassis

can anyone share the Switching fabric Midplane and backplane architecture information and images and how it helps in forwarding and scaling the Modulor switch architecture.

DNA Center inventory error - NCIM12024:

Hi, we encountered this error after we discovered the device on the dna center. We tried to resync the device, but the same error appeared. If you have any tips on how to make this work i will appreciate it.Internal Error : NCIM12024: All information...

SSH Server Public Key Too Small Vulnerability on DNAC

Any suggestion on fixing the above VA in DNAC or how to check the existing SSH public key length in DNAC

Provision Catalyst 9300 switch to Catalyst Center

I am trying to provision a Cisco Catalyst 9300 switch (running firmware 17.09.04a) to Catalyst Center (version 2.3.7.7). I was able to add the switch to a site, but when provisioning the switch, I get the error message "PKI Config push Failed - Unabl...

Can I automate fixing vlan mismatches reported in Inventory Insights?

Hi All,Just wanted to find out if there was a way to fix these mismatches (by either deleting the mismatch or adding the missing vlans) without manually doing it on the switches since we have more than 100 of these being reported by DNA center.. Tha...

Monitoring of Catalyst/DNA Center itself

Hi,I wonder which is the best way to monitor our DNA Center appliance. We have all our networking infrastructure monitored and we want to have DNA Center also under this tool (from SolarWinds). We usually monitor using icmp and SNMP. Is it possible t...

Resolved! Catalyst Center Wireless Network Profiles Policy Tags

I was creating a wireless network profile in Catalyst Center to deploy to my 9800 WLC.I was wanting to use the same custom policy tag for multiple sites that would have the same SSIDs broadcasting. I can't seem to select multiple sites when I create ...

Cisco 9300L - Console output on boot but no interaction after

Trying to connect to the console on a brand new 9300 switch. No previous configuration applied. RJ45 & USB ports both scroll bootup messages but refuse to respond after. Tried multiple cables, terminal settings, USB keyboard, laptops but no change. I...

3750g etherchannel with two Fortigate Firewalls in HA

Hi guys,have anybody experience with topology where is one cisco catalyst 3750g switch and two Fortigate firewalls in HA active - passive mode?Here is the topology:On cisco switch I have ports GigabitEthernet1/0/23 and 24 added in port-channel with i...