Cisco DNA GUI not working

[suresh-sharma]

Cisco DNA GUI not working
and Checked by me 
magctl appstack status  :   working

magctl appstack status | grep 0/  (no all working)

all Docker Container working
Cli wokring 
maglev catalog package display  (All Package deployed)

magctl service status  (running)

Only issue GUI not wokring and not able see "DNA GUI not working"

[Torbjørn]

Is this a fresh install/has the GUI been available previously? Does it respond to port 443 at all?

[suresh-sharma]

this is fresh installations and GUI not coming up
I tried 2 times but the issue same GUI not coming.

checked all kubelet conatiners,packakes all running fine. what issue can possiable 

is there any DNS issue 

[Torbjørn]

Has the node been running for long after first boot? Takes quite a while for everything to come up fully.

Is this a hardware appliance install or virtual? Does it have the resources required?

[balaji.bandi]

When you installing DNAC First time , make sure you meet the pre-requisites, and DNAC required to access Internet to get packages

command line - maglev package status  (make sure all ok before you get access to GUI)

depends on internet speed - it took for me 4 to 6 hours, some time a Day to complete whole installation)