Cisco DNAC - Image Update Readiness Check

[ziqex]

Hi,

I have noticed that during Image Update Readiness Check the config register check it is showing the warning for config register values.

As below:

Please change the Config-register value

Expected: 0x2102,0x102

Actual: 0x142 (will be 0x102 at next reload)

Action: Suggestion is to change Config-register to expected/default value

Why the action suggests changing the config-register value?

I have re-checked show romvar 

SWITCH_IGNORE_STARTUP_CFG="0"

Should DNAC not see that the value at next reload will be 0x102?

Thank you.

[pieterh]

I suggest the reboot has not taken place yet after the romvar has been changed
-> this would explain the status:  Actual: 0x142 (will be 0x102 at next reload)

[ziqex · Accepted solution]

DNAC should not provide suggested action as changing the config-register. As the config register value will change automatically at the next reload which is required anyway for deploying new firmware.