07-15-2022 03:52 PM
Hi everyone
Someone know how get the ip address of CIMC server of DNA center?
I'm recently check a DNA that already is installed and wish that IP address to management the server(hardware)
My model is DN2-HW-APL-U.
Thank you so much
07-15-2022 11:42 PM
- If you are aware of the subnet the address is in , you may perform an nmap scan on it and detect the address with nmap results.
M.
07-16-2022 12:53 AM
if the CIMC is not configured with an IP address you won't be able to get that information.
I will check where the port is connected, and check the MAC and arp table to find that information.
07-18-2022 08:50 AM
The DNA software is completely isolated form CIMC, by design, so that won't be the place to look for CIMC information. You can, however, use the hardware KVM or USB/VGA ports on the appliance to access CIMC config. See the "Enable Browser Access to Cisco Integrated Management Controller" section of this install guide:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide