I seem to have worked myself into a corner on this one waiting for TAC support contract to come thru. Essentially, I built out a fabric site in DNAC and added a C9300 switch to said fabric, in doing so I added several VN's as "Use Border/CP fort his site to be common for the Virtual Network" (not exactly knowing what that meant because documentation is not very clear on this). Anyways, after doing this I realized that all of this was setup on the site level instead of the configured Fabric Zone level of the hierarchy. Now it seems I cannot remove the VN's to start over, I can go in and uncheck the check box and hit deploy and I get a success message however, the VN still shows anchored with no underlying configurations? At this point I tried to remove the switch from the Fabric and it fails saying it can't be removed with L3 Handoff configured (assuming VN related), I tried deleting the fabric and it says can't delete because devices are assigned. I guess the problem is I just want to start over and I cannot for the life of me figure out how to do this? Any help would be appreciated.
