Hello.I've just started to learn CCNA as a total beginner, with some basic knowledge in IT.I used to study with a friend the first time 2 times, but he doesn't have the motivation for it.If anyone wants to study together through a voice call, I think...
Forum Posts
hi all, my customer buyed the licenses relating to the IW6300 access points were purchased in C1 mode with the relative subscription for the duration of 3 years, they will now expire soon.what will happen when they expire? can we buy the AIR-DNA-A-3...
Hello everyone, When performing the migration of maps from Prime to DNAC, do the ID's remain the same? This is important for an integration with Aeroscout. Thank you in advance!
Hello All,Need helping understanding if its possible to extract all the trunk ports on my network via DNAC (Version 2.3.3.6). I have 300+ L2/L3 switches in my environment many of which are configured with trunk ports. I need to make a system wide cha...
Hello Guys,I was just wondering what the proper way to reset the maglev CLI password was. I found this guide (https://www.cisco.com/c/en/us/support/docs/cloud-systems-management/dna-center/218052-reset-cisco-dna-center-s-maglev-user-pas.html) but ca...
I want to disable feature DNA as netflow collector? How can I do it? Is it possible?Or maybe I can change default template? I don't want to see ipv6 netflow configurations on my devices
Hello,I can't seem to provision a Configuration Template for a Catalyst 9400 switch. The same Template works fine on a Catalyst 9300 Switch. I did add the Class of switches - 9400 Series Switches within the Template Editor Configuration. Committed th...
Hello,we are currently in the process of converting our telephone system to Voice over IP and integrating it into our DNA Center. In addition to the hardware IP phones, we would also like to use the Jabber soft client. The problem is that IP traffic ...
Hi, I am trying to install a DNA Center and use the 169.254.32.0/20 and 169.254.48.0/20 APIPA addresses as recommended in the documentation: https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2...
I am having issues getting both the enterprise and the management ports to be reachable on my DNA appliance. I put the default-gateway on the management and static routes on the enterprise and the enterprise is reachable but the management isn't. If ...
I manually registered the switch. It's not blocked by a firewall. Because SSH is not availableRegistered with telnet.But what should I do if this message pops up? Device Connectivity Failure : NCIM12008: Connectivity to the device could not be esta...
HiI am trying (and failing) to provision our 5520 WLC from DNAC. When looking through the details, it shows failed on "WSA Certificate push failed".Any suggestions to try? Is this likely to be a DNAC issue or a WLC issue?Thanks
Cisco DNAC cannot get health from most NADS But It changes, so screenshot below shows that 10.32.21.5 gets health score of 10, but e.g. 10.32.22.5 says “no health” Then 10 minutes after, it says no health, but suddenly 10.32.22.5 that previously said...
Hi, how can I export raw config (unsanitized as in CPI) in last verison DNAC
I have a new implementation of Cisco DNA I'm working on without our VAR or Support (right now.) I'm trying to integrate ISE and I See this error below:I've tried to apply the same Root CA in DNAC and ISE. I've been fiddling with the Root CA on the IS...
