09-01-2021 12:00 AM
Dear Community
DNA 2.1.2.7 - We are facing an issue while do switch port configuration via CLI or Template, it never reflect the configuration on FABRIC > Host onboarding > Port Assignment page. We tried to resync the devices many times but no luck - Any idea? is there anyway to sync both CLI and port assignment page?
Similarly the port assignment page is not reflecting the port status as well, it may take a while to show the port up or down. resync wont help.
Appreciate your response.
09-01-2021 12:14 AM
is this new deployment or the issue encounter after upgrade /
look release notes see any bugs reported :
09-01-2021 02:26 AM
Hi Balaji
Its a new deployment, and we are seeing this from day one though we have done multiple upgrades.
09-01-2021 05:19 AM
A few things to check/consider:
-What version of IOS are you running on the NADs in question? See here for compatibility: Cisco Software-Defined Access Compatibility Matrix
-What platform is/are the NAD/s in question?
-What is the status of the device/s in question in DNAC inventory? Is it fully managed? Please share any issues/errors.
-Do you have any working NADs? If so, I would suggest a comparison of the working vs. nonworking.
-Have you planted a seed with TAC to identify any possible bugs?
09-01-2021 06:13 AM
@Mike.Cifelli , its 9300 with 17.3.3 - devices are very much compatible. Yes, its fully managed and we are can sync without any errors. we have 400+ same devices, whichever we tested is got the issue. I did not ask TAC in a separate case, but i have raised the question to TAC in a case which is got similar issues. I thought i will check with community whether anyone else facing the issue or not. before approaching TAC i would like to know from the field professionals.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide