Recently set up 6 new 9200s. Configuration based off previous 2 9200 switches. I have been adding cameras all week, and finally came to a PTZ camera. While connected to the newly configured switches, when the PTZ is moved (set to 4mbps/30fps), these will drop to ~2mbps / 15fps or less. Fixed cameras seem ok, but there isn't a whole lot of motion on them at the current time. I have compared the switch configs with notepad+ and there's nothing major sticking out. I will upload the configs in the morning. The new switches are connected via fiber to sfp on 9300. Two 9200s on 2 different fiber runs are experiencing the same thing, with multiple PTZs tested. I do not experience the issue on my PoE switch up in my data room, which is connected via Cat6.
