PNP for 9800 WLC using Service port

[DanishAsh07225]

Hi All,

I am having C9800-L-C-K9 and trying to provision using pnp in DNAC center. 

WLC SERVICE PORT is connected to access layer switch via trunk. WLC got IP using DHCP and joined DNAC but when i try to claim device in PnP its not showing Interface to select.

can someone confirm if there is anything i am missing ,or its not supported to claim device using Service port.

i have attached DNAC snip where port is not showing and config on service port at WLC side.

[balaji.bandi]

Look at this thread and requirement version of code :

https://community.cisco.com/t5/cisco-digital-network/pnp-for-9800-wlc-using-service-port/m-p/4301600