Possibly the Dumbest Question in Here...

[Wade Patterson]

Created a lab in CML 2 (VIRL2). 

Need to add another device. 

Added the new device, connected to other devices... can't bootstrap it.

Shutdown lab, attempted to apply bootstrap configs, started lab, new device is at the initial config dialogue.

How do I get the newly added device to have a bootstrap config?

[Martin L · Accepted solution]

last tab "edit config" I think is called (one after console tab, vnc tab) shows you initial config of a device.  you make any changes before even starting device, otherwise it is locked and you must wipe out device. 

The main Doc is at https://developer.cisco.com/docs/modeling-labs/#!introduction

The online support /forum is at CLN site

Regards, ML
**Please Rate All Helpful Responses **