Adding IoT Devices to an existing network!

[nghuman1]

I have this existing campus network design, and I want to add Iot devices in it, can somebody help me with detailed steps how do i go about it?

[Flavio Miranda]

Hi

Is it a PacketTracer Project? Which device you want to add? 

 Share the PacketTracer file here. Zip it first.

[nghuman1]

Yes, it is a packet tracer project, where I have designed a campus network headquartered in Toronto having 5 different departments! I want to add 2 VoIP phones that communicate from one department to other! Also an IoT device such as a Camera! I have attached the Pkt file below. Thanks

[Flavio Miranda]

Hello

 find attached a file with voice and camera.  The Voice feature on the PT is quite good, you can pickup on phone and call another one. Just rover the mouse over the phone in order to see the number. Then , type the number on the key board and press enter on your keyboard and then the other phone rings. You can click on the other phone and hoop up.

The camera is installed but I think the camera feature is very limited. i did not play much with if. Hope you enjoy it!