cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
435
Views
0
Helpful
1
Replies

Cisco Firepower 1000 Series

Mohamed Sh
Level 1
Level 1

Hi,

I have a Cisco Firepower 1000 Series and this is my first time configuring it, after I configured some basic interface IPs and routing I clicked on start deployment. After that I couldn't access the Firepower from browser.

I erased configuration from cli local management and tried to access again but still couldn't.

Could anyone advice me with the solution?

1 Accepted Solution

Accepted Solutions

balaji.bandi
Hall of Fame
Hall of Fame
after I configured some basic interface IPs and routing I clicked on start deployment

if you change from default IP to different IP you may lost connection.

Make sure you have console access, check is the new configuraion applied on the device, if so, change your PC IP to same range IP to get GUI access ?

getting started guide :

https://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/fp1100/firepower-1100-gsg/ftd-fmc.html

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

1 Reply 1

balaji.bandi
Hall of Fame
Hall of Fame
after I configured some basic interface IPs and routing I clicked on start deployment

if you change from default IP to different IP you may lost connection.

Make sure you have console access, check is the new configuraion applied on the device, if so, change your PC IP to same range IP to get GUI access ?

getting started guide :

https://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/fp1100/firepower-1100-gsg/ftd-fmc.html

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help