Packet Tracer Bug

[KeeganCouture1072]

in our IT class we have recently run into and reproduced every time
a bug that prevents password entry in packet tracer cmd as far as it has been seen so Far
this issue only exists in cmd mode in which after entering a user name it prevents any
text from being entered and

 

preventing password entry not allowing ,pka assignment to be finished.
i will run a test to see if this can be replicated in open sandbox. please reply if you have seen
this problem or have a solution. (for image you have to note that it is
not allowing any keyboard input into the cmd)  Disscovered on 1.5.3.6 Packet Tracer - Comunication in a Cyber World.pka

[All Knowing Knower]

Didn't ask

[KeeganCouture1072]

Neither did the development team.

[All Knowing Knower]

you are lame

[All Knowing Knower]

*insert appropriate comment*

[BingerBonger]

Binger

[KeeganCouture1072]

reproduced this bug in open sand box on router did not try switch. 

attached is an image of where the bug occurred and the .pkt file inside the zip of the setup that was used.

[TJ-20933766]

Bug must just be on that version of Packet Tracer. I just tested your .pkt file using version 7.3 and it worked just fine using telnet from one of the PCs to the router. I also used the CLI as depicted in your latest picture and was able to get in just fine.

[KeeganCouture1072]

which version of packet tracer are you using we may have to update an entire classroom 

and are you using 32bit or 64bit we are on 32bit

[KeeganCouture1072]

i reread your reply we are on version 7.2.0

[KeeganCouture1072]

same results on packet tracer 8.0.0 on 32bit 

this means that this is a 32bit bug

[KeeganCouture1072]

i have also now tested on 7.3.1 on 32 bit with the same results 

[annamalaiaardhanarieswarar]

while I am using the straight though cable packet has sending & I am using the cross though cable packet has sending 

right method is straight though cable & in cross though cable packet will not sent