Cisco User Groups Discussions

We're holding a two-day online conference with six sessions, each a couple hours long with roughly a half hour break in between. The first day runs from 8 - 5, again with breaks. The second runs 8 -4. I only want folks to register once for the entire...

I am getting an alert in Solarwinds as below:     subslot 0/0 transceiver 0 Rx Power Sensor is Critical   In the specified device I checked the status of subslot as below:   INT-RT#sh hw-module subslot 0/0 transceiver 0 status The Transceiver in slot...

My questions are: as WIKI does not seem to have enough definitive info, is there a time-frame for global implementation? Does e.164 and e164.arpa need to operate together, or can e.164 operate without it? I've been looking for a status of e.164, so i...

I have set up all my speed dials for desk hardware phone. Is there a way to import to the Windows version of IP Phone? 

We're deploying new domain controllers to hundreds of sites, so I am writing a script to point the Cisco IMCs to the new domain controller. Looking for the specific PowerShell cmdlet (Cisco.IMC module) to set the preferred and alternate DNS servers i...

would anyone happen to know what Call Manager version this is based on? thanks much

Hi,We have requirement to permit some URLs on port no example 1000these URLs we want to allow access to our Users,link.student.comJlink.studentclass.comMy asa version = 9.2(2)4Need to permit above URLs in ASA port no :1000 in bidirectional.

My firewall has configured for 3 iPs1- for 0 port 10.80.xx.xx2- for 1 port 10.80.xx.xy3- for firewall itself 10.80.xx.xzBut i am able to ping from other ips also why?  Can we asign more iPs to 1 port of firewall to allow more iPs to data access

I have completed my Graduation in the year 2015 with Science background from Noida. I am looking for best Cisco CCNA training institutes in Noida to grow my career as a CCNA routing and switching master. Can any one please help me to find the best CC...

Hi, what is the Mean Time Between Failure for Cisco Prime Infrastructure and Cisco Mobility Services Engine?Thanks.

Hello,In June 2018 I passed the exam (210-250) Understanding Cisco Cybersecurity Fundamentals (SECFND), and a few months later (September - October 2018) I failed the (210-255) Implementing Cisco Cybersecurity Operations (SECOPS).Now I want to resume...

There is a command in CIsco_ASA "show run username" .And the output of this command is like the following :username test password xxxxxxxxxxx encrypted privilege 5 ==> This user was created with privilege 5username test1 password xxxxxx encrypted ==>...

Hi all, hope you are doing well. I have 2 questions: 1. we have 5520 wlc and we want use web auth so our virtual ip is 1.1.1.1 and it is ok but when we changing ip from 1.1.1.1 to example 192.0.2.1 when guest connect guest wifi the login page not ope...

I have two VLAN's on a single switch. When I ping to see the connectivity between the devices, the nodes on different VLAN's are not communicating. It shows packet sent 4, received 0. How the nodes on different VLAN's can communicate?

Our customer has the ISR4321/K9 router . When IOS was upgraded from existing version 15.5.2 to 16.06 Everest, it trigger firmware version upgrade as well. This behaviours was not expected during IOS upgrade activity. Can anyone please advise why? You...