11-28-2016 09:13 PM
I see the API ref.
In the document, I can use request header as below
<header>
</header>
<securityContext>
<webExID>hostid</webExID>
<password>hostpassword</password>
<siteID>0000</siteID>
</securityContext>
When the user use SSO (like cisco IT), what parameters should I enter?
Could you please give me the example?
Solved! Go to Solution.
11-29-2016 10:31 AM
For SSO Enabled sites you would need to perform an AuthenticateUser request first, it will return a sessionTicket element you then use instead of the password element.
<securityContext>
<webExID>hostid</webExID>
<sessionTicket>sessionTicket</sessionTicket>
<siteName>webexSite</siteName>
</securityContext>
also note siteName is recommended over siteID/PartnerID
11-29-2016 10:31 AM
For SSO Enabled sites you would need to perform an AuthenticateUser request first, it will return a sessionTicket element you then use instead of the password element.
<securityContext>
<webExID>hostid</webExID>
<sessionTicket>sessionTicket</sessionTicket>
<siteName>webexSite</siteName>
</securityContext>
also note siteName is recommended over siteID/PartnerID
12-01-2016 03:20 AM
Thanks Ryan.
I'll try this
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: