cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
563
Views
1
Helpful
1
Replies

Cisco Umbrella - Network Device registration - behind NAT

llomjaria
Level 1
Level 1

Hello,

I am trying to register c1111-8p as network device in Umbrella. On device I am using following configuration:

Device# configure terminal
Device(config)# parameter-map type umbrella global
Device(config-profile)#dnscrypt
Device(config-profile)#token AABBA59A0BDE1485C912AFE472952641001EEECC
Device(config-if)# exit

Device(config)# interface gi0/0/0.2
Device(config-if)# umbrella out

Device(config)# interface gigabitEthernet 0/0/0.3
Device(config-if)# umbrella in DEVICETAG

Registration on device is successful:

show umbrella deviceid - status is registered.

On Umbrella portal device shows as registered but status is offline

llomjaria_0-1702484370901.png

The router is behind a NAT. After Cisco router,  there is a Mikrotik which is connected to the internet. 

Can this be the cause of the "offline" status ?

 

1 Reply 1

adamwin
Cisco Employee
Cisco Employee

NAT will not impact this. Are you sending traffic yet? I think the 'active' status may require some DNS traffic to be sent.