Dear all.
I have a customer that want to connect to Umbrella SIG Gateway with IPsec Tunnels.
Because there will be around 1-2GB Traffice we need to configure 4-8 Tunnels (at moment per tunnel 250MBit later 500MBit)
I found following information at Umbrella site for basics Network Tunnel Configuration (umbrella.com)
Here are an example for ISR configuration Manual: Cisco ISR (umbrella.com)
In my opinion, if I configure more than one default routes that point to different tunnels. The system should to automatically ECMP between the VPN tunnels.
VPN Tunnels to Umbrella SIG are up and running, but I need to check if ECMP is working as expected, and how flows distributed through different tunnels ?
Can some tell me what commands I should use to check if ECMP is working ?
Thanks in advance.
Christian
