12-21-2011 03:40 PM - edited 03-17-2019 02:12 PM
Hi Guys,
I'll be deploying the new jabber client for a customer and i'm unsure of what QoS to configure on the switch ports for end users. Users will also have 7942 handsets, so if i configure auto qos voip cisco-phone, I doubt this will protect the voice/video for Jabber.
Has anyone got any config or tips they can share?
Cheers,
James
Solved! Go to Solution.
12-21-2011 09:20 PM
Hi,
I believe you can use "auto qos voip cisco-softphone"
Please see below QOS SRND.
http://www.cisco.com/univercd/cc/td/doc/solution/esm/qossrnd.pdf
Regards
Ronak
12-21-2011 07:20 PM
Hi James,
For jabber QoS we should have a DSCP value where the signal is CS3 and the media is the DSCP value passed down from UCM.
Regards
Ronak Patel
12-21-2011 09:01 PM
HI Ronak,
So are you saying there is no auto QoS for Jabber? So do i just configure MQC using ACLs and apply the sevice policy to all LAN interfaces with the Jabber client?
12-21-2011 09:20 PM
Hi,
I believe you can use "auto qos voip cisco-softphone"
Please see below QOS SRND.
http://www.cisco.com/univercd/cc/td/doc/solution/esm/qossrnd.pdf
Regards
Ronak
02-10-2012 07:29 PM
Hi Ronak,
Thanks for the reply, thats the same conclusion i came to after reading the QoS SRND. Just wanted to see what others thought.
Cheers,
James
08-10-2017 01:03 PM
Guys,
I have a question to this thread,
When user connects his laptop to the physical IP Phone Port(daisy-chained), and uses cisco jabber to answer the calls instead of hard phone. How can we trust Both Soft Phone and Hard Phone in single Port?
It is not possible to apply both the Below commands.
auto qos voip cisco-phone
auto qos voip Cisco-softphone
Any inputs?
Regards
Safwan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide