CWMS 4.0(1): Jabber and ESXi Support
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2019 02:49 AM
Hello!
I have still a customer with an CWMS installation. We want to upgrade to version 4.0(1).
I found also the release notes for that version (updated on July the 5th 2019) and now I have two questions about the support for Jabber and ESXi.
Jabber 12.6(0) and ESXi 6.5 are supported.
Did that mean:
- Jabber 12.6(1) is not supported and therefore we can not use that version?
- Did somebody know, when ESXi 6.7U1 (cisco custom image is available) will be supported for CWMS, too?
Source:
thanks and best regards
Benjamin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2019 01:15 PM
Hi there
Answering your first question about Jabber 12.6.1 support, I should say you have wait for the updated release notes of CWMS 4.X. The one currently is updated by June 5 and Jabber 12.6.1 is released on June-13. My guess, just wait for the document update.
These roadmaps you can actually touch base with your Cisco AM/SE
Hope this Helps
Cheers
Rath!
***Please rate helpful posts***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-22-2019 11:19 PM
Hello Rath,
ok I can wait for another update of documentation or new release. In my opinion the last update was made at 5th of July for that document.
But anywhy at the moment Jabber 12.6.1 it is not supported.
Will think about further options.
Best regards
Benjamin
