Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
359
Views
5
Helpful
1
Replies

Meetingplace 8.6 and MTP

gfolens
Level 4
Level 4

‎06-17-2014 12:51 AM - edited ‎03-17-2019 04:14 PM

According to the Meetingplace 8.6 documentation the MTP on the CUCM SIP trunk needs to be disabled.

But when I disable MTP the calls to MP are failing. What could be the cause (codec?) and what is best practice?

rgds, Geert.

Labels:
0 Helpful
1 Reply 1

dpetrovi
Cisco Employee
Cisco Employee

‎06-18-2014 08:53 AM

Hi Geert,

 

If you want transcoding to be done on MeetingPlace, you would need to enable High Quality in System Configuration > Media Resource Configuration. This will of course cut the resource pool significantly. 

If you use High Capacity mode, then MP can negotiate only G711 and if the calls are coming from CUCM to MP with a codec other than G711, the call will drop. 

MeetingPlace doesn't really care if you have MTP enabled on CUCM as long as you have enough resources on CUCM to support terminating every call coming to MP on CUCM. 

-Dejan

Customers Also Viewed These Support Documents